Replacing Upper or Lower Fan Tray
▀ Removing an Upper Fan Tray
▄ ASR 5000 Installation Guide
Removing an Upper Fan Tray
Follow the instructions below to remove an upper fan tray from the chassis.
Step 1 Remove the plastic bezel from the upper-front of the chassis by placing your fingers in the notches on the sides of the
bezel and pulling it toward you.
Step 2 Use a Phillips #1 screwdriver to loosen the four screws securing the fan tray.
Step 3 Grasp the two bezel mounts on the front of the fan tray and pull toward you. The fan tray should easily slide out of the
chassis.
WARNING: The upper fan tray assembly contains multiple fans that are spinning at a high rate of speed when the
system is powered on. If system is powered on, do not touch moving fans. To minimize the risk of personal injury and
potential damage to equipment, follow these instructions.
1. Pull the fan tray towards you until the fan tray extends out of the chassis approximately two inches
(5 cm).
2. Wait 30 seconds to allow fans to stop spinning.
3. Fully remove fan tray.
To Next Page
Loading...
