EasyManuals Logo

Cisco Catalyst 3120 Command Reference Guide

Cisco Catalyst 3120
982 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #115 background imageLoading...
Page #115 background image
2-87
Cisco Catalyst Blade Switch 3120 for HP Command Reference
OL-12248-01
Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands
diagnostic start
diagnostic start
Use the diagnostic start privileged EXEC command to run an online diagnostic test.
diagnostic start switch number test {name | test-id | test-id-range | all | basic | non-disruptive}
Syntax Description
Defaults This command has no default setting.
Command Modes Privileged EXEC
Command History
Usage Guidelines The switch supports these tests:
ID Test Name [On-Demand Test Attributes]
--- -------------------------------------------
1 TestPortAsicStackPortLoopback [B*N****]
2 TestPortAsicLoopback [B*D*R**]
3 TestPortAsicCam [B*D*R**]
4 TestPortAsicRingLoopback [B*D*R**]
5 TestMicRingLoopback [B*D*R**]
6 TestPortAsicMem [B*D*R**]
7 TestInlinePwrCtlr [B*D*R**]
--- -------------------------------------------
When specifying a test name, use the show diagnostic content privileged EXEC command to display
the test ID list. To specify test 3 by using the test name, enter the diagnostic start switch number test
TestPortAsicCam privileged EXEC command.
switch number Specify the switch number, which is the stack member number. If the
switch is a standalone switch, the switch number is 1. If the switch is in a
stack, the range is 1 to 9, depending on the switch member numbers in the
stack.
test Specify the tests to run.
name Specify the name of a test. For more information, see the “Usage
Guidelines” section.
test-id Specify the ID number of a test. The range is from 1 to 7. For more
information, see the “Usage Guidelines” section.
test-id-range Specify more than one test with the range of test ID numbers. For more
information, see the “Usage Guidelines” section.
all Specify all the diagnostic tests.
basic Specify the basic on-demand diagnostic tests.
non-disruptive Specify the nondisruptive health-monitoring tests.
Release Modification
12.2(40)EX This command was introduced.

Table of Contents

Other manuals for Cisco Catalyst 3120

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 3120 and is the answer not in the manual?

Cisco Catalyst 3120 Specifications

General IconGeneral
BrandCisco
ModelCatalyst 3120
CategorySwitch
LanguageEnglish

Related product manuals