B-9
Cisco Catalyst Blade Switch 3120 for HP Command Reference
OL-12248-01
Appendix B Cisco Catalyst Blade Switch 3120 for HP Debug Commands
debug fastethernet
debug fastethernet
Use the debug fastethernet privileged EXEC command to enable debugging of the Ethernet
management port. Use the no form of this command to disable debugging.
debug fastethernet {af | events | packets}
no debug fastethernet {af | events | packets}
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug fastethernet {af | events | packets} command is the same as the no debug fastethernet
{af | events | packets} command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands
af Display Ethernet management port software-address-filter debug messages.
events Display Ethernet management port event debug messages.
packets Display Ethernet management port packet debug messages.
Release Modification
12.2(40)EX This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.
show controllers
ethernet-controller
fastethernet
Displays information about the Ethernet management port.