2-387
Cisco Catalyst Blade Switch 3120 for HP Command Reference
OL-12248-01
Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands
show arp access-list
show arp access-list
Use the show arp access-list user EXEC command to display detailed information about Address
Resolution Protocol (ARP) access control (lists).
show arp access-list [acl-name] [ | {begin | exclude | include} expression]
This command is available only if your switch is running the IP services feature set.
Syntax Description
Command Modes User EXEC
Command History
Usage Guidelines Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
are not displayed, but the lines that contain Output are displayed.
Examples This is an example of output from the show arp access-list command:
Switch> show arp access-list
ARP access list rose
permit ip 10.101.1.1 0.0.0.255 mac any
permit ip 20.3.1.0 0.0.0.255 mac any
Related Commands
acl-name (Optional) Name of the ACL.
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
Release Modification
12.2(40)EX This command was introduced.
Command Description
arp access-list Defines an ARP ACL.
deny (ARP access-list
configuration)
Denies an ARP packet based on matches against the Dynamic Host
Configuration Protocol (DHCP) bindings.
ip arp inspection filter vlan Permits ARP requests and responses from a host configured with a
static IP address.
permit (ARP access-list
configuration)
Permits an ARP packet based on matches against the DHCP bindings.
To Next Page
Loading...
Need help?
General