B-27
Cisco Catalyst Blade Switch 3120 for HP Command Reference
OL-12248-01
Appendix B Cisco Catalyst Blade Switch 3120 for HP Debug Commands
debug platform configuration
debug platform configuration
Use the debug platform configuration privileged EXEC command to enable debugging of
configuration file activity across the stack. Use the no form of this command to disable debugging.
debug platform configuration {all | reception | transmission}
no debug platform configuration {all | reception | transmission}
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug platform configuration command is the same as the no debug platform configuration
command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands
all Display debug messages for all configuration file transmission and reception events
throughout the stack.
reception Display debug messages for configuration file reception from other stack members.
transmission Display debug messages for configuration file transmission to other stack members.
Release Modification
12.2(40)EX This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.
To Next Page
Loading...
Need help?
General