Cisco Catalyst 3120

B-17
Cisco Catalyst Blade Switch 3120 for HP Command Reference
OL-12248-01
Appendix B Cisco Catalyst Blade Switch 3120 for HP Debug Commands
debug mac-notification
debug mac-notification
Use the debug mac-notification privileged EXEC command to enable debugging of MAC notification
events. Use the no form of this command to disable debugging.
debug mac-notification
no debug mac-notification
Syntax Description This command has no arguments or keywords.
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug mac-notification command is the same as the no debug mac-notification command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands
Release Modification
12.2(40)EX This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.
show mac
address-table
notification
Displays the MAC address notification information for all interfaces or the
specified interface.