Cisco Catalyst 3120 Command Reference Guide

2-68
Cisco Catalyst Blade Switch 3120 for HP Command Reference
OL-12248-01
Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands
copy logging onboard
copy logging onboard
Use the copy logging onboard privileged EXEC command on the switch stack or on a standalone switch
to copy on-board failure logging (OBFL) data to the local network or a specific file system.
copy logging onboard module stack-member destination
Syntax Description
Defaults This command has no default setting.
Command Modes Privileged EXEC
Command History
module
stack-member
Specify the stack member number. If the switch is a standalone switch, the switch
number is 1. If the switch is in a stack, the range is 1 to 9, depending on the switch
member numbers in the stack.
destination Specify the location on the local network or file system to which the system
messages are copied.
For destination, specify the destination on the local or network file system and the
filename. These options are supported:
• The syntax for the local flash file system:
flash[number]:/filename
Use the number parameter to specify the stack member number of the stack
master. The range for number is 1 to 9.
• The syntax for the FTP:
ftp://username:password@host/filename
• The syntax for an HTTP server:
http://[[username:password]@]{hostname | host-ip}[/directory]/filename
• The syntax for the NVRAM:
nvram:/filename
• The syntax for the null file system:
null:/filename
• The syntax for the Remote Copy Protocol (RCP):
rcp://username@host/filename
• The syntax for the switch file system:
system:filename
• The syntax for the temporary file system:
tmpsys:/filename
• The syntax for the TFTP:
tftp:[[//location]/directory]/filename
Release Modification
12.2(40)EX This command was introduced.

Cisco Catalyst 3120 Specifications

General

Brand	Cisco
Model	Catalyst 3120
Category	Switch
Language	English