Cisco Catalyst 3120 Command Reference Guide

2-388
Cisco Catalyst Blade Switch 3120 for HP Command Reference
OL-12248-01
Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands
show auto qos
show auto qos
Use the show auto qos user EXEC command to display the quality of service (QoS) commands entered
on the interfaces on which automatic QoS (auto-QoS) is enabled.
show auto qos [interface [interface-id]]
Syntax Description
Command Modes User EXEC
Command History
Usage Guidelines The show auto qos command output shows only the auto-QoS command entered on each interface. The
show auto qos interface interface-id command output shows the auto-QoS command entered on a
specific interface.
Use the show running-config privileged EXEC command to display the auto-QoS configuration and the
user modifications.
Beginning in Cisco IOS Release 12.2(40)SE, the show auto qos command output shows the service
policy information for the Cisco IP phone.
To display information about the QoS configuration that might be affected by auto-QoS, use one of these
commands:
• show mls qos
• show mls qos maps cos-dscp
• show mls qos interface [interface-id] [buffers | queueing]
• show mls qos maps [cos-dscp | cos-input-q | cos-output-q | dscp-cos | dscp-input-q |
dscp-output-q]
• show mls qos input-queue
• show running-config
Examples This is an example of output from the show auto qos command after the auto qos voip cisco-phone and
the auto qos voip cisco-softphone interface configuration commands are entered:
Switch> show auto qos
GigabitEthernet2/0/4
auto qos voip cisco-softphone
GigabitEthernet2/0/5
auto qos voip cisco-phone
interface [interface-id] (Optional) Display auto-QoS information for the specified port or
for all ports. Valid interfaces include physical ports.
Release Modification
12.2(40)EX This command was introduced.

Cisco Catalyst 3120 Specifications

General

Brand	Cisco
Model	Catalyst 3120
Category	Switch
Language	English