Cisco Catalyst 3120 Command Reference Guide

B-4
Cisco Catalyst Blade Switch 3120 for HP Command Reference
OL-12248-01
Appendix B Cisco Catalyst Blade Switch 3120 for HP Debug Commands
debug backup
debug backup
Use the debug backup privileged EXEC command to enable debugging of the Flex Links backup
interface. Use the no form of this command to disable debugging.
debug backup {all | errors | events | vlan-load-balancing}
no debug backup {all | errors | events | vlan-load-balancing}
Syntax Description
Command Default Backup interface debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug backup command is the same as the no debug backup command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands
all Display all backup interface debug messages.
errors Display backup interface error or exception debug messages.
events Display backup interface event debug messages.
vlan-load-
balancing
Display backup interface VLAN load balancing.
Release Modification
12.2(40)EX This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.

Cisco Catalyst 3120 Specifications

General

Brand	Cisco
Model	Catalyst 3120
Category	Switch
Language	English