B-33
Cisco Catalyst Blade Switch 3120 for HP Command Reference
OL-12248-01
Appendix B Cisco Catalyst Blade Switch 3120 for HP Debug Commands
debug platform fallback-bridging
debug platform fallback-bridging
Use the debug platform fallback-bridging privileged EXEC command to enable debugging of the
platform-dependent fallback bridging manager. Use the no form of this command to disable debugging.
debug platform fallback-bridging [error | retry | rpc {events | messages}]
no debug platform fallback-bridging [error | retry | rpc {events | messages}]
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines If you do not specify a keyword, all fallback bridging manager debug messages appear.
The undebug platform fallback-bridging command is the same as the no debug platform
fallback-bridging command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands
error (Optional) Display fallback bridging manager error condition messages.
retry (Optional) Display fallback bridging manager retry messages.
rpc {events | messages} (Optional) Display fallback bridging debugging information. The
keywords have these meanings:
• events—Display remote procedure call (RPC) events.
• messages—Display RPC messages.
Release Modification
12.2(40)EX This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.