EasyManuals Logo

Cisco Catalyst 3120 Command Reference Guide

Cisco Catalyst 3120
982 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #693 background imageLoading...
Page #693 background image
2-665
Cisco Catalyst Blade Switch 3120 for HP Command Reference
OL-12248-01
Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands
spanning-tree vlan
spanning-tree vlan
Use the spanning-tree vlan global configuration command on the switch stack or on a standalone switch
to configure spanning tree on a per-VLAN basis. Use the no form of this command to return to the
default setting.
spanning-tree vlan vlan-id [forward-time seconds | hello-time seconds | max-age seconds |
priority priority | root {primary | secondary} [diameter net-diameter
[hello-time seconds]]]
no spanning-tree vlan vlan-id [forward-time | hello-time | max-age | priority | root]
Syntax Description
Defaults Spanning tree is enabled on all VLANs.
The forward-delay time is 15 seconds.
The hello time is 2 seconds.
The max-age is 20 seconds.
vlan-id VLAN range associated with a spanning-tree instance. You can specify a
single VLAN identified by VLAN ID number, a range of VLANs separated
by a hyphen, or a series of VLANs separated by a comma. The range is 1 to
4094.
forward-time seconds (Optional) Set the forward-delay time for the specified spanning-tree
instance. The forwarding time specifies how long each of the listening and
learning states last before the interface begins forwarding. The range is 4 to
30 seconds.
hello-time seconds (Optional) Set the interval between hello bridge protocol data units
(BPDUs) sent by the root switch configuration messages. The range is 1 to 10
seconds.
max-age seconds (Optional) Set the interval between messages the spanning tree receives
from the root switch. If a switch does not receive a BPDU message from the
root switch within this interval, it recomputes the spanning-tree topology.
The range is 6 to 40 seconds.
priority priority (Optional) Set the switch priority for the specified spanning-tree instance.
This setting affects the likelihood that the switch is selected as the root
switch. A lower value increases the probability that the switch is selected
as the root switch.
The range is 0 to 61440 in increments of 4096. Valid priority values are
4096, 8192, 12288, 16384, 20480, 24576, 28672, 32768, 36864, 40960,
45056, 49152, 53248, 57344, and 61440. All other values are rejected.
root primary (Optional) Force this switch to be the root switch.
root secondary (Optional) Set this switch to be the root switch should the primary root
switch fail.
diameter net-diameter (Optional) Set the maximum number of switches between any two end
stations. The range is 2 to 7.

Table of Contents

Other manuals for Cisco Catalyst 3120

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 3120 and is the answer not in the manual?

Cisco Catalyst 3120 Specifications

General IconGeneral
BrandCisco
ModelCatalyst 3120
CategorySwitch
LanguageEnglish

Related product manuals