B-8
Cisco Catalyst Blade Switch 3120 for HP Command Reference
OL-12248-01
Appendix B Cisco Catalyst Blade Switch 3120 for HP Debug Commands
debug etherchannel
debug etherchannel
Use the debug etherchannel privileged EXEC command to enable debugging of the
EtherChannel/PAgP shim. This shim is the software module that is the interface between the Port
Aggregation Protocol (PAgP) software module and the port manager software module. Use the no form
of this command to disable debugging.
debug etherchannel [all | detail | error | event | idb]
no debug etherchannel [all | detail | error | event | idb]
Syntax Description
Note Though visible in the command-line help strings, the linecard keyword is not supported.
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines If you do not specify a keyword, all debug messages appear.
The undebug etherchannel command is the same as the no debug etherchannel command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands
all (Optional) Display all EtherChannel debug messages.
detail (Optional) Display detailed EtherChannel debug messages.
error (Optional) Display EtherChannel error debug messages.
event (Optional) Debug major EtherChannel event messages.
idb (Optional) Display PAgP interface descriptor block debug messages.
Release Modification
12.2(40)EX This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.
show etherchannel Displays EtherChannel information for the channel.
To Next Page
Loading...
Need help?
General