B-52
Cisco Catalyst Blade Switch 3120 for HP Command Reference
OL-12248-01
Appendix B Cisco Catalyst Blade Switch 3120 for HP Debug Commands
debug platform port-security
debug platform port-security
Use the debug platform port-security privileged EXEC command to enable debugging of
platform-dependent port-security information. Use the no form of this command to disable debugging.
debug platform port-security {add | aging | all | delete | errors | rpc | warnings}
no debug platform port-security {add | aging | all | delete | errors | rpc | warnings}
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug platform port-security command is the same as the no debug platform port-security
command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands
add Display secure address addition debug messages.
aging Display secure address aging debug messages.
all Display all port-security debug messages.
delete Display secure address deletion debug messages.
errors Display port-security error debug messages.
rpc Display remote procedure call (RPC) debug messages.
warnings Display warning debug messages.
Release Modification
12.2(40)EX This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.
To Next Page
Loading...
Need help?
General