B-58
Cisco Catalyst Blade Switch 3120 for HP Command Reference
OL-12248-01
Appendix B Cisco Catalyst Blade Switch 3120 for HP Debug Commands
debug platform stack-manager
debug platform stack-manager
Use the debug platform stack-manager privileged EXEC command to enable debugging of the stack
manager software. Use the no form of this command to disable debugging.
debug platform stack-manager {all | rpc | sdp | sim | ssm | trace}
no debug platform stack-manager {all | rpc | sdp | sim | ssm | trace}
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug platform stack-manager command is the same as the no debug platform
stack-manager command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands
all Display all stack manager debug messages.
rpc Display stack manager remote procedure call (RPC) usage debug messages.
sdp Display the Stack Discovery Protocol (SDP) debug messages.
sim Display the stack information module debug messages.
ssm Display the stack state-machine debug messages.
trace Trace the stack manager entry and exit debug messages.
Release Modification
12.2(40)EX This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.
To Next Page
Loading...
Need help?
General