2-542
Cisco Catalyst Blade Switch 3120 for HP Command Reference
OL-12248-01
Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands
show mls qos aggregate-policer
show mls qos aggregate-policer
Use the show mls qos aggregate-policer user EXEC command to display the quality of service (QoS)
aggregate policer configuration. A policer defines a maximum permissible rate of transmission, a
maximum burst size for transmissions, and an action to take if either maximum is exceeded.
show mls qos aggregate-policer [aggregate-policer-name] [ | {begin | exclude | include}
expression]
Syntax Description
Command Modes User EXEC
Command History
Usage Guidelines Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
Examples This is an example of output from the show mls qos aggregate-policer command:
Switch> show mls qos aggregate-policer policer1
aggregate-policer policer1 1000000 2000000 exceed-action drop
Not used by any policy map
Related Commands
aggregate-policer-name (Optional) Display the policer configuration for the specified name.
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
Release Modification
12.2(40)EX This command was introduced.
Command Description
mls qos aggregate-policer Defines policer parameters that can be shared by multiple classes
within a policy map.
To Next Page
Loading...
Need help?
General