Cisco Catalyst 3120

B-59
Cisco Catalyst Blade Switch 3120 for HP Command Reference
OL-12248-01
Appendix B Cisco Catalyst Blade Switch 3120 for HP Debug Commands
debug platform supervisor-asic
debug platform supervisor-asic
Use the debug platform supervisor-asic privileged EXEC command to enable debugging of the
supervisor application-specific integrated circuit (ASIC). Use the no form of this command to disable
debugging.
debug platform supervisor-asic {all | errors | receive | send}
no debug platform supervisor-asic {all | errors | receive | send}
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug platform supervisor-asic command is the same as the no debug platform
supervisor-asic command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands
all Display all supervisor-ASIC event debug messages.
errors Display the supervisor-ASIC error debug messages.
receive Display the supervisor-ASIC receive debug messages.
send Display the supervisor-ASIC send debug messages.
Release Modification
12.2(40)EX This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.