Cisco Catalyst 3120 Command Reference Guide

2-102
Cisco Catalyst Blade Switch 3120 for HP Command Reference
OL-12248-01
Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands
dot1x default
dot1x default
Use the dot1x default interface configuration command on the switch stack or on a standalone switch
to reset the IEEE 802.1x parameters to their default values.
dot1x default
Syntax Description This command has no arguments or keywords.
Defaults These are the default values:
• The per-port IEEE 802.1x protocol enable state is disabled (force-authorized).
• The number of seconds between re-authentication attempts is 3600 seconds.
• The periodic re-authentication is disabled.
• The quiet period is 60 seconds.
• The retransmission time is 30 seconds.
• The maximum retransmission number is 2 times.
• The host mode is single host.
• The client timeout period is 30 seconds.
• The authentication server timeout period is 30 seconds.
Command Modes Interface configuration
Command History
Examples This example shows how to reset the IEEE 802.1x parameters on a port:
Switch(config-if)# dot1x default
You can verify your settings by entering the show dot1x [interface interface-id] privileged EXEC
command.
Related Commands
Release Modification
12.2(40)EX This command was introduced.
Command Description
show dot1x [interface interface-id] Displays IEEE 802.1x status for the specified port.

Cisco Catalyst 3120 Specifications

General

Brand	Cisco
Model	Catalyst 3120
Category	Switch
Language	English