B-7
Cisco Catalyst Blade Switch 3120 for HP Command Reference
OL-12248-01
Appendix B Cisco Catalyst Blade Switch 3120 for HP Debug Commands
debug eap
debug eap
Use the debug eap privileged EXEC command to enable debugging of the Extensible Authentication
Protocol (EAP) activity. Use the no form of this command to disable debugging.
debug dot1x {all | authenticator | errors | events | md5 | packets | peer | sm}
no debug dot1x {all | authenticator | errors | events | md5 | packets | peer | sm}
Syntax Description
Command Default Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug dot1x command is the same as the no debug dot1x command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands
all Display all EAP debug messages.
authenticator Display authenticator debug messages.
errors Display EAP error debug messages.
events Display EAP event debug messages.
md5 Display EAP-MD5 debug messages.
packets Display EAP packet debug messages.
peer Display EAP peer debug messages.
sm Display EAP state-machine related-events debug messages.
Release Modification
12.2(40)EX This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.
show eap Displays EAP registration and session information for the switch or for the
specified port.
To Next Page
Loading...
Need help?
General