EasyManuals Logo

Cisco Catalyst 3120 Command Reference Guide

Cisco Catalyst 3120
982 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #301 background imageLoading...
Page #301 background image
2-273
Cisco Catalyst Blade Switch 3120 for HP Command Reference
OL-12248-01
Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands
mls qos aggregate-policer
mls qos aggregate-policer
Use the mls qos aggregate-policer global configuration command on the switch stack or on a standalone
switch to define policer parameters, which can be shared by multiple classes within the same policy map.
A policer defines a maximum permissible rate of transmission, a maximum burst size for transmissions,
and an action to take if either maximum is exceeded. Use the no form of this command to delete an
aggregate policer.
mls qos aggregate-policer aggregate-policer-name rate-bps burst-byte exceed-action {drop |
policed-dscp-transmit}
no mls qos aggregate-policer aggregate-policer-name
Syntax Description
Defaults No aggregate policers are defined.
Command Modes Global configuration
Command History
Usage Guidelines Define an aggregate policer if the policer is shared with multiple classes.
Policers for a port cannot be shared with other policers for another port; traffic from two different ports
cannot be aggregated for policing purposes.
The port ASIC device, which controls more than one physical port, supports 256 policers on the switch
(255 user-configurable policers plus 1 policer reserved for internal use). The maximum number of
configurable policers supported per port is 63. Policers are allocated on demand by the software and are
constrained by the hardware and ASIC boundaries. You cannot reserve policers per port (there is no
guarantee that a port will be assigned to any policer).
You apply an aggregate policer to multiple classes in the same policy map; you cannot use an aggregate
policer across different policy maps.
aggregate-policer-name Name of the aggregate policer referenced by the police aggregate
policy-map class configuration command.
rate-bps Specify the average traffic rate in bits per second (b/s). The range
is 8000 to 1000000000.
burst-byte Specify the normal burst size in bytes. The range is 8000 to 1000000.
exceed-action drop When the specified rate is exceeded, specify that the switch drop the
packet.
exceed-action
policed-dscp-transmit
When the specified rate is exceeded, specify that the switch change the
Differentiated Services Code Point (DSCP) of the packet to that
specified in the policed-DSCP map and then send the packet.
Release Modification
12.2(40)EX This command was introduced.

Table of Contents

Other manuals for Cisco Catalyst 3120

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 3120 and is the answer not in the manual?

Cisco Catalyst 3120 Specifications

General IconGeneral
BrandCisco
ModelCatalyst 3120
CategorySwitch
LanguageEnglish

Related product manuals