EasyManuals Logo

Cisco Catalyst 3120 Command Reference Guide

Cisco Catalyst 3120
982 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #250 background imageLoading...
Page #250 background image
2-222
Cisco Catalyst Blade Switch 3120 for HP Command Reference
OL-12248-01
Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands
ipv6 traffic-filter
ipv6 traffic-filter
Use the ipv6 traffic-filter interface configuration command on the switch stack or on a standalone
switch to filter IPv6 traffic on an interface. The type and direction of traffic that you can filter depends
on the feature set running on the switch stack. Use the no form of this command to disable the filtering
of IPv6 traffic on an interface.
ipv6 traffic-filter access-list-name {in | out}
no ipv6 traffic-filter access-list-name {in | out}
Note This command is available only if you have configured a dual IPv4 and IPv6 Switch Database
Management (SDM) template on the switch.
Syntax Description
Defaults Filtering of IPv6 traffic on an interface is not configured.
Command Modes Interface configuration
Command History
Usage Guidelines To configure the dual IPv4 and IPv6 template, enter the sdm prefer dual-ipv4-and-ipv6 {default | vlan)
global configuration command and reload the switch.
You can use the ipv6 traffic-filter command on physical interfaces (Layer 2 or Layer 3 ports), Layer 3
port channels, or switch virtual interfaces (SVIs).
If the switch stack is running the advanced IP services feature set, you can apply an ACL to outbound or
inbound traffic on Layer 3 interfaces (port ACLs), or to inbound traffic on Layer 2 interfaces (router
ACLs). If the switch stack is running the IP services or IP base feature set, you can apply ACLs only to
inbound management traffic on Layer 3 interfaces. Switches running the IP services or IP base feature
set do not support port ACLs.
If any port ACL (IPv4, IPv6, or MAC) is applied to an interface, that port ACL is used to filter packets,
and any router ACLs attached to the SVI of the port VLAN are ignored.
access-list-name Specify an IPv6 access name.
in Specify incoming IPv6 traffic.
out Specify outgoing IPv6 traffic.
Note The out keyword is not supported for Layer 2 interfaces (port
ACLs). If the switch stack is running the IP services or IP base
feature set, the out keyword is not supported for Layer 3 interfaces.
Release Modification
12.2(40)EX This command was introduced.

Table of Contents

Other manuals for Cisco Catalyst 3120

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 3120 and is the answer not in the manual?

Cisco Catalyst 3120 Specifications

General IconGeneral
BrandCisco
ModelCatalyst 3120
CategorySwitch
LanguageEnglish

Related product manuals