Cisco Catalyst 3120 Command Reference Guide

B-24
Cisco Catalyst Blade Switch 3120 for HP Command Reference
OL-12248-01
Appendix B Cisco Catalyst Blade Switch 3120 for HP Debug Commands
debug platform acl
debug platform acl
Use the debug platform acl privileged EXEC command to enable debugging of the access control list
(ACL) manager. Use the no form of this command to disable debugging.
debug platform acl {all | exit | label | main | racl | stack | vacl | vlmap | warn}
no debug platform acl {all | exit | label | main | racl | stack | vacl | vlmap | warn}
Syntax Description
Command Default Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug platform acl command is the same as the no debug platform acl command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands
all Display all ACL manager debug messages.
exit Display ACL exit-related debug messages.
label Display ACL label-related debug messages.
main Display the main or important ACL debug messages.
racl Display router ACL related debug messages.
stack Display ACL stack-related debug messages.
vacl Display VLAN ACL-related debug messages.
vlmap Display ACL VLAN-map-related debug messages.
warn Display ACL warning-related debug messages.
Release Modification
12.2(40)EX This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.

Cisco Catalyst 3120 Specifications

General

Brand	Cisco
Model	Catalyst 3120
Category	Switch
Language	English