Cisco Catalyst 3120 Command Reference Guide

B-83
Cisco Catalyst Blade Switch 3120 for HP Command Reference
OL-12248-01
Appendix B Cisco Catalyst Blade Switch 3120 for HP Debug Commands
debug sw-vlan notification
debug sw-vlan notification
Use the debug sw-vlan notification privileged EXEC command to enable debugging of the activation
and deactivation of Inter-Link Switch (ISL) VLAN IDs. Use the no form of this command to disable
debugging.
debug sw-vlan notification {accfwdchange | allowedvlancfgchange | fwdchange | linkchange |
modechange | pruningcfgchange | statechange}
no debug sw-vlan notification {accfwdchange | allowedvlancfgchange | fwdchange |
linkchange | modechange | pruningcfgchange | statechange}
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug sw-vlan notification command is the same as the no debug sw-vlan notification
command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
accfwdchange Display debug messages for VLAN manager notification of aggregated
access interface spanning-tree forward changes.
allowedvlancfgchange Display debug messages for VLAN manager notification of changes to the
allowed VLAN configuration.
fwdchange Display debug messages for VLAN manager notification of spanning-tree
forwarding changes.
linkchange Display debug messages for VLAN manager notification of interface
link-state changes.
modechange Display debug messages for VLAN manager notification of interface mode
changes.
pruningcfgchange Display debug messages for VLAN manager notification of changes to the
pruning configuration.
statechange Display debug messages for VLAN manager notification of interface state
changes.
Release Modification
12.2(40)EX This command was introduced.

Cisco Catalyst 3120 Specifications

General

Brand	Cisco
Model	Catalyst 3120
Category	Switch
Language	English