B-43
Cisco Catalyst Blade Switch 3120 for HP Command Reference
OL-12248-01
Appendix B Cisco Catalyst Blade Switch 3120 for HP Debug Commands
debug platform ipc
debug platform ipc
Use the debug platform ipc privileged EXEC command to enable debugging of the platform-dependent
Interprocess Communication (IPC) Protocol. Use the no form of this command to disable debugging.
debug platform ipc {all | init | receive | send | trace}
no debug platform {all | init | receive | send | trace}
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug platform ipc command is the same as the no debug platform ipc.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands
all Display all platform IPC debug messages.
Note Using this command can degrade the performance of the switch.
init Display debug messages related to IPC initialization.
receive Display IPC traces each time an IPC packet is received by the switch.
send Display IPC traces each time an IPC packet is sent by the switch.
trace Display IPC trace debug messages, tracing the code path as the IPC functions are
executed.
Release Modification
12.2(40)EX This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.
To Next Page
Loading...
Need help?
General