Cisco Catalyst 3750-E - Page 15

Contents
xv
Catalyst 3750-E and 3560-E Switch Software Configuration Guide
OL-9775-08
Default Ethernet Interface Configuration 12-22
Configuring Interface Speed and Duplex Mode 12-23
Speed and Duplex Configuration Guidelines 12-23
Setting the Interface Speed and Duplex Parameters 12-24
Configuring IEEE 802.3x Flow Control 12-25
Configuring Auto-MDIX on an Interface 12-26
Configuring a Power Management Mode on a PoE Port 12-27
Budgeting Power for Devices Connected to a PoE Port 12-28
Configuring Power Policing 12-30
Adding a Description for an Interface 12-31
Configuring Layer 3 Interfaces 12-32
Configuring SVI Autostate Exclude 12-33
Configuring the System MTU 12-34
Configuring the Cisco RPS 2300 12-37
Configuring the Power Supplies 12-38
Monitoring and Maintaining the Interfaces 12-39
Monitoring Interface Status 12-40
Clearing and Resetting Interfaces and Counters 12-41
Shutting Down and Restarting the Interface 12-42
CHAPTER 13 Configuring VLANs 13-1
Understanding VLANs 13-1
Supported VLANs 13-2
VLAN Port Membership Modes 13-3
Configuring Normal-Range VLANs 13-4
Token Ring VLANs 13-5
Normal-Range VLAN Configuration Guidelines 13-5
Configuring Normal-Range VLANs 13-6
Saving VLAN Configuration 13-6
Default Ethernet VLAN Configuration 13-7
Creating or Modifying an Ethernet VLAN 13-8
Deleting a VLAN 13-9
Assigning Static-Access Ports to a VLAN 13-9
Configuring Extended-Range VLANs 13-10
Default VLAN Configuration 13-10
Extended-Range VLAN Configuration Guidelines 13-11
Creating an Extended-Range VLAN 13-11
Creating an Extended-Range VLAN with an Internal VLAN ID 13-13
Displaying VLANs 13-14