Cisco Catalyst 9500 Series

PurposeCommand or Action
Returns to privileged EXEC mode.end
Example:
Device(config)# end
Step 13
Verifies the reset by checking information about the
routing table and about BGP neighbors.
show ip bgp
Example:
Device# show ip bgp
Step 14
Verifies the reset by checking information about the
routing table and about BGP neighbors.
show ip bgp neighbors
Example:
Device# show ip bgp neighbors
Step 15
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Device# copy running-config
Step 16
startup-config
Configuring BGP Filtering with Route Maps
Procedure
PurposeCommand or Action
Enters the global configuration mode.configure terminal
Example:
Device# configure terminal
Step 1
Creates a route map, and enter route-map
configuration mode.
route-map map-tag [permit | deny]
[sequence-number]
Example:
Device(config)# route-map
set-peer-address permit 10
Step 2
(Optional) Sets a route map to disable next-hop
processing
set ip next-hop ip-address [...ip-address]
[peer-address]
Step 3
Routing Configuration Guide, Cisco IOS XE Everest 16.6.x (Catalyst 9500 Switches)
131
Configuring IP Unicast Routing
Configuring BGP Filtering with Route Maps