Cisco Catalyst 9500 Series

Procedure
PurposeCommand or Action
Enables privileged EXEC mode. Enter your password
if prompted.
enable
Example:
Device> enable
Step 1
Enters the global configuration mode.configure terminal
Example:
Device# configure terminal
Step 2
Configure the Device to send SA request messages
to the specified MSDP peer.
ip msdp sa-request {ip-address | name}
Example:
Device(config)# ip msdp sa-request
Step 3
For ip-address | name, enter the IP address or name
of the MSDP peer from which the local Device
requests SA messages when a new member for a
group becomes active.
171.69.1.1
Repeat the command for each MSDP peer that you
want to supply with SA messages.
Returns to privileged EXEC mode.end
Example:
Device(config)# end
Step 4
Verifies your entries.show running-config
Example:
Device# show running-config
Step 5
(Optional) Saves your entries in the configuration
file.
copy running-config startup-config
Example:
Device# copy running-config
Step 6
startup-config
Controlling Source Information that Your Switch Originates
You can control the multicast source information that originates with your Device:
Routing Configuration Guide, Cisco IOS XE Everest 16.6.x (Catalyst 9500 Switches)
32
Configuring MSDP
Controlling Source Information that Your Switch Originates