Cisco Catalyst 9500 Series

PurposeCommand or Action
Specifies the source IP address for FTP
connections.
ip ftp source-interface interface-type
interface-number
Example:
Device(config)# ip ftp source-interface
gigabitethernet 1/0/2
Step 2
Returns to privileged EXEC mode.end
Example:
Device(config)#end
Step 3
Enters global configuration mode.configure terminal
Example:
Device# configure terminal
Step 4
Specifies the source IP address for TFTP
connections.
ip tftp source-interface interface-type
interface-number
Example:
Device(config)# ip tftp source-interface
gigabitethernet 1/0/2
Step 5
Returns to privileged EXEC mode.end
Example:
Device(config)# end
Step 6
Configuring Multicast VRFs
For complete syntax and usage information for the commands, see the switch command reference for this
release and the Cisco IOS IP Multicast Command Reference.
For more information about configuring a multicast within a Multi-VRF CE, see the IP Routing:
Protocol-Independent Configuration Guide, Cisco IOS Release 15S.
Routing Configuration Guide, Cisco IOS XE Everest 16.6.x (Catalyst 9500 Switches)
170
Configuring IP Unicast Routing
Configuring Multicast VRFs