Cisco Catalyst 9500 Series

PurposeCommand or Action
Returns to privileged EXEC mode.end
Example:
Device(config)# end
Step 5
Verifies your entries.show running-config
Example:
Device# show running-config
Step 6
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Device# copy running-config
Step 7
startup-config
Configuring an MSDP Mesh Group
An MSDP mesh group is a group of MSDP speakers that have fully meshed MSDP connectivity among one
another. Any SA messages received from a peer in a mesh group are not forwarded to other peers in the same
mesh group. Thus, you reduce SA message flooding and simplify peer-RPF flooding. Use the ip msdp
mesh-group global configuration command when there are multiple RPs within a domain. It is especially
used to send SA messages across a domain. You can configure multiple mesh groups (with different names)
in a single Device.
Follow these steps to create a mesh group:
Procedure
PurposeCommand or Action
Enables privileged EXEC mode. Enter your password
if prompted.
enable
Example:
Device> enable
Step 1
Enters the global configuration mode.configure terminal
Example:
Device# configure terminal
Step 2
Routing Configuration Guide, Cisco IOS XE Everest 16.6.x (Catalyst 9500 Switches)
42
Configuring MSDP
Configuring an MSDP Mesh Group