Cisco Catalyst 9500 Series

PurposeCommand or Action
Enters global configuration mode.configure terminal
Example:
Router# configure terminal
Step 2
Disables BFD echo mode.no bfd echo
Step 3
Example:
Router(config)# no bfd echo
•
Use the no form to disable BFD echo mode.
Exits global configuration mode and returns to
privileged EXEC mode.
end
Example:
Router(config)# end
Step 4
Creating and Configuring BFD Templates
You can configure a single-hop template to specify a set of BFD interval values. BFD interval values specified
as part of the BFD template are not specific to a single interface.
Configuring bfd-template will disable echo mode.Note
Configuring a Single-Hop Template
Perform this task to create a BFD single-hop template and configure BFD interval timers.
Procedure
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
Device> enable
•
Enter your password if prompted.
Enters global configuration mode.configure terminal
Example:
Device# configure terminal
Step 2
Routing Configuration Guide, Cisco IOS XE Everest 16.6.x (Catalyst 9500 Switches)
22
Configuring Bidirectional Forwarding Detection
How to Configure Bidirectional Forwarding Detection