EasyManuals Logo

Cisco Catalyst 9500 Series User Manual

Cisco Catalyst 9500 Series
222 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #78 background imageLoading...
Page #78 background image
Routing Assistance When IP Routing is Disabled
These mechanisms allow the Device to learn about routes to other networks when it does not have IP routing
enabled:
Proxy ARP
Default Gateway
ICMP Router Discovery Protocol (IRDP)
Proxy ARP
Proxy ARP is enabled by default. To enable it after it has been disabled, see the Enabling Proxy ARP section.
Proxy ARP works as long as other routers support it.
Default Gateway
Another method for locating routes is to define a default router or default gateway. All non-local packets are
sent to this router, which either routes them appropriately or sends an IP Control Message Protocol (ICMP)
redirect message back, defining which local router the host should use. The Device caches the redirect messages
and forwards each packet as efficiently as possible. A limitation of this method is that there is no means of
detecting when the default router has gone down or is unavailable.
Procedure
PurposeCommand or Action
Enables privileged EXEC mode. Enter your
password if prompted.
enable
Example:
Device> enable
Step 1
Enters the global configuration mode.configure terminal
Example:
Device# configure terminal
Step 2
Sets up a default gateway (router).
ip default-gateway ip-address
Example:
Device(config)# ip default gateway
10.1.5.1
Step 3
Routing Configuration Guide, Cisco IOS XE Everest 16.6.x (Catalyst 9500 Switches)
68
Configuring IP Unicast Routing
Routing Assistance When IP Routing is Disabled

Table of Contents

Other manuals for Cisco Catalyst 9500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 9500 Series and is the answer not in the manual?

Cisco Catalyst 9500 Series Specifications

General IconGeneral
SeriesCatalyst 9500 Series
CategorySwitch
SoftwareCisco IOS XE
Operating Temperature0°C to 45°C (32°F to 113°F)
Storage Temperature-40°C to 70°C (-40°F to 158°F)
Fixed Uplink ModulesVaries by model
StackingYes (StackWise Virtual)
RedundancyRedundant power supplies and fans
SecurityAdvanced security features
PoE+Available (varies by model)
Power Supply OptionsAC and DC options (varies by model)
Relative Humidity5% to 90% noncondensing
Dimensions (H x W x D)Varies by model
WeightVaries by model
PortsUp to 48 ports (varies by model)

Related product manuals