Cisco Catalyst 9500 Series

PurposeCommand or Action
Example:
Device(config-if)# standby 1 ip 10.0.0.11
(Optional) Enables HSRP support for BFD
on the interface.
standby bfd
Example:
Device(config-if)# standby bfd
Step 7
Exits interface configuration mode.exit
Example:
Device(config-if)# exit
Step 8
(Optional) Enables HSRP support for BFD
on all interfaces.
standby bfd all-interfaces
Example:
Device(config)# standby bfd
all-interfaces
Step 9
Exits global configuration mode.exit
Example:
Device(config)# exit
Step 10
(Optional) Displays information about
HSRP support for BFD.
show standby neighbors
Example:
Device# show standby neighbors
Step 11
Configuring BFD Support for Static Routing
Perform this task to configure BFD support for static routing. Repeat the steps in this procedure on each BFD
neighbor. For more information, see the "Example: Configuring BFD Support for Static Routing" section.
Procedure
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Routing Configuration Guide, Cisco IOS XE Everest 16.6.x (Catalyst 9500 Switches)
18
Configuring Bidirectional Forwarding Detection
How to Configure Bidirectional Forwarding Detection