Cisco Catalyst 9500 Series

How to Configure RIP
Default RIP Configuration
Table 8: Default RIP Configuration
Default SettingFeature
Enabled.Auto summary
Disabled.Default-information
originate
Built-in; automatic metric translations.Default metric
No authentication.
Authentication mode: clear text.
IP RIP authentication
key-chain
DisabledIP RIP triggered
Varies with media.IP split horizon
None defined.Neighbor
None specified.Network
Disabled.Offset list
0 milliseconds.Output delay
•
Update: 30 seconds.
•
Invalid: 180 seconds.
•
Hold-down: 180 seconds.
•
Flush: 240 seconds.
Timers basic
Enabled.Validate-update-source
Receives RIP Version 1 and 2 packets; sends Version 1 packets.Version
Routing Configuration Guide, Cisco IOS XE Everest 16.6.x (Catalyst 9500 Switches)
81
Configuring IP Unicast Routing
How to Configure RIP