Cisco Catalyst 9500 Series

Procedure
PurposeCommand or Action
Enables privileged EXEC mode. Enter your
password if prompted.
enable
Example:
Device> enable
Step 1
Enters the global configuration mode.configure terminal
Example:
Device# configure terminal
Step 2
Configures the RP address in SA messages to
be the address of the originating device
interface.
ip msdp originator-id interface-id
Example:
Device(config)# ip msdp originator-id
Step 3
For interface-id, specify the interface on the
local Device.
0/1
Returns to privileged EXEC mode.end
Example:
Device(config)# end
Step 4
Verifies your entries.show running-config
Example:
Device# show running-config
Step 5
(Optional) Saves your entries in the
configuration file.
copy running-config startup-config
Example:
Device# copy running-config
Step 6
startup-config
Monitoring and Maintaining MSDP
Commands that monitor MSDP SA messages, peers, state, and peer status:
Routing Configuration Guide, Cisco IOS XE Everest 16.6.x (Catalyst 9500 Switches)
47
Configuring MSDP
Monitoring and Maintaining MSDP