Cisco Catalyst 9500 Series

PurposeCommand or Action
Returns to privileged EXEC mode.end
Example:
Device(config)# end
Step 7
Verifies the configuration on the interface or all
interfaces
show ip interface [interface-id]
Example:
Device# show ip interface
Step 8
Verifies your entries.show running-config
Example:
Device# show running-config
Step 9
(Optional) Saves your entries in the configuration
file.
copy running-config startup-config
Example:
Device# copy running-config
Step 10
startup-config
Forwarding UDP Broadcast Packets and Protocols
If you do not specify any UDP ports when you configure the forwarding of UDP broadcasts, you are configuring
the router to act as a BOOTP forwarding agent. BOOTP packets carry DHCP information.
Procedure
PurposeCommand or Action
Enables privileged EXEC mode. Enter your
password if prompted.
enable
Example:
Device> enable
Step 1
Enters the global configuration mode.configure terminal
Example:
Device# configure terminal
Step 2
Routing Configuration Guide, Cisco IOS XE Everest 16.6.x (Catalyst 9500 Switches)
73
Configuring IP Unicast Routing
Configuring Broadcast Packet Handling