Cisco Catalyst 9500 Series

PurposeCommand or Action
Enables SNMP traps for packets on a VRF.snmp-server trap authentication vrf
Example:
Device(config)# snmp-server trap
authentication vrf
Step 2
Configures a name for the remote SNMP
engine on a switch.
snmp-server engineID remote host vrf vpn-instance
engine-id string
Example:
Device(config)# snmp-server engineID remote
Step 3
172.16.20.3 vrf vpn1
80000009030000B064EFE100
Specifies the recipient of an SNMP trap
operation and specifies the VRF table to
be used for sending SNMP traps.
snmp-server host host vrf vpn-instance traps
community
Example:
Device(config)# snmp-server host 172.16.20.3
vrf vpn1 traps comaccess
Step 4
Specifies the recipient of an SNMP inform
operation and specifies the VRF table to
be used for sending SNMP informs.
snmp-server host host vrf vpn-instance informs
community
Example:
Device(config)# snmp-server host 172.16.20.3
vrf vpn1 informs comaccess
Step 5
Adds a user to an SNMP group for a
remote host on a VRF for SNMP access.
snmp-server user user group remote host vrf
vpn-instance security model
Example:
Device(config)# snmp-server user abcd remote
Step 6
172.16.20.3 vrf vpn1 priv v2c 3des
secure3des
Returns to privileged EXEC mode.end
Example:
Device(config-if)# end
Step 7
Configuring VRF-Aware Servcies for uRPF
uRPF can be configured on an interface assigned to a VRF, and source lookup is done in the VRF table.
For complete syntax and usage information for the commands, refer to the switch command reference for this
release and the Cisco IOS Switching Services Command Reference, Release 12.4.
Routing Configuration Guide, Cisco IOS XE Everest 16.6.x (Catalyst 9500 Switches)
166
Configuring IP Unicast Routing
Configuring VRF-Aware Services