Cisco Catalyst 9500 Series

Procedure
PurposeCommand or Action
Enables privileged EXEC mode. Enter your
password if prompted.
enable
Example:
Device> enable
Step 1
Enters the global configuration mode.configure terminal
Example:
Device# configure terminal
Step 2
Shuts down the specified MSDP peer without
losing configuration information.
ip msdp shutdown {peer-name | peer
address}
Step 3
Example:
Device(config)# ip msdp shutdown
For peer-name | peer address, enter the IP
address or name of the MSDP peer to shut
down.
switch.cisco.com
Returns to privileged EXEC mode.end
Example:
Device(config)# end
Step 4
Verifies your entries.show running-config
Example:
Device# show running-config
Step 5
(Optional) Saves your entries in the
configuration file.
copy running-config startup-config
Example:
Device# copy running-config
Step 6
startup-config
Including a Bordering PIM Dense-Mode Region in MSDP
You can configure MSDP on a Device that borders a PIM sparse-mode region with a dense-mode region. By
default, active sources in the dense-mode region do not participate in MSDP.
Routing Configuration Guide, Cisco IOS XE Everest 16.6.x (Catalyst 9500 Switches)
44
Configuring MSDP
Including a Bordering PIM Dense-Mode Region in MSDP