Citrix SD-WAN Series - Installing the Appliance; Rack Mount the Appliance

To Next Page

To Previous Page

Citrix SD-WAN Platforms

Front Panel SD-WAN Instance

SD-WAN 1000 PE SD-WAN 2000 PE

MGMT (Blue) 0/1 (LOM/PRI) Primary

AUX 0/2 (AUX) Aux

apA LAN1/WCCP (Green) 1/1 apA.1

apA WAN1 1/2 apA.2

apB LAN2 1/3 apB.1*

apB WAN2 1/4 apB.2*

Available to the SD-WAN instance only in four-port mode.

Installing the Appliance

May 23, 2019

Aer you have determined that the location where you install your appliance meets the environmen-

tal standards and the server rack is in place according to the instructions, you are ready to install the

hardware. Aer you mount the appliance, you are ready to connect it to the network, to a power

source, and to the console terminal that you will use for initial configuration. You can also connect

the appliance to a computer through Ethernet port for initial configuration. On SD-WAN 1000 PE ap-

pliance, this port is labeled as MGMT (management) port and on SD-WAN 2000 PE, the port is labeled

as PRI (primary) port. To complete the installation, you switch on the appliance. Be sure to observe

the cautions and warnings listed with the installation instructions.

Rack Mount the Appliance

May 23, 2019

An SD-WAN 1000 PE (EE) or 2000 PE (EE) appliance requiresone rack unit. Botharerack-mount devices

that can be installed into two-post relay racks or four-post EIA-310 server racks. Verify that the rack is

compatible with your appliance.