Citrix SD-WAN Platforms
• High Availability setup for SD-WAN AMI instances is not supported.
• SD-WAN AMI instance in Group Mode is not supported.
• SD-WAN plug-ins are not supported.
• Tagged VLAN is not supported because of the inherent limitation of AWS.
• Traic shaping is not supported.
• You may create only an m1.large SD-WAN AMI instance on AWS.
• IP address/gateway/subnet assignment using the SD-WAN management user interface is not
supported.
• Console access is not available for SD-WAN AMI instance on AWS.
• While configuring the SD-WAN instance, you may not change the disk size, which has a default
value of 250 GB. A higher capacity disk does not increase the available Disk Based Compression
(DBC) cache size.
Deploy SD-WAN WANOP VPX on Microso Azure
June 19, 2020
Citrix SD-WAN WANOP Edition is now available in the Azure Marketplace, enabling WAN optimization
between enterprise datacenter/branch and Azure cloud. Since L2 mode support is not available on
cloud infrastructures, you cannot deploy Citrix SD-WAN WANOP as a standalone VPX in Azure Cloud.
However, you can deploy Citrix SD-WAN WANOP VPX along with Citrix ADC VPX in Azure cloud infras-
tructure. The Citrix ADC VPX uses cloud connector to create an IPsec tunnel, while the SD-WAN WANOP
VPX accelerates the connections, providing LAN-like performance for applications.
Citrix SD-WAN WANOP in Azure cloud topology
The topology diagram shows an SD-WAN 4000 or 5000 appliance deployed in the data center or
branch premises. You can also deploy SD-WAN WANOP and SD-WAN SE appliances in two-box mode
or it can both be VPX. On the Azure cloud VNET, the SD-WAN WANOP VPX is deployed in one-arm
(PBR) mode with the Citrix ADC VPX.
© 1999-2021 Citrix Systems, Inc. All rights reserved. 391
To Next Page
Loading...