Citrix SD-WAN Platforms
2. Align the 10G SFP+ transceiver to the front of the 10G SFP+ transceiver port on the front panel
of the appliance.
3. Hold the 10G SFP+ transceiver between your thumb and index finger and insert it into the 10G
SFP+ transceiver port, pressing it in until you hear the transceiver snap into place.
4. Move the locking hinge to the DOWN position.
5. Verify that the LED is green and blinks twice, which indicates that the transceiver is functioning
correctly.
6. Do not remove the dust caps attached to the transceiver and cable until you are ready to insert
the cable.
Warning
Do not look directly into fiber optic transceivers and cables. They emit laser beams that can
damage your eyes.
To remove a 10G SFP+ transceiver
1. Disconnect the cable from the 10G SFP+ transceiver. Replace the dust cap on the cable before
putting it away.
2. Unlock the 10G SFP+ transceiver by moving the locking hinge to the UP position.
3. Hold the 10G SFP+ transceiver between your thumb and index finger and slowly pull it out of
the port.
4. Replace the dust cap on the transceiver before putting it away.
5. Put the 10G SFP+ transceiver into its original box or another appropriate container.
Regulatory compliance
November 17, 2020
Supplier’s declaration of conformity
The FCC Compliance Statements listed on this page apply to all Citrix SD-WAN hardware models.
Responsible Party – U.S. Contact Information:
1 Citrix Systems, Inc.
2 4988 Great America Parkway
3 Santa Clara, CA
4 95054 USA
5
6 compliance.prime@citrix.com
© 1999-2021 Citrix Systems, Inc. All rights reserved. 421
To Next Page
Loading...
Need help?
General