EasyManua.ls Logo

Citrix SD-WAN Series - Overview of VPX Installation and Deployment; Virtual Ethernet Ports Per VPX-SE;VPXL-SE Platforms

Citrix SD-WAN Series
424 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Citrix SD-WAN Platforms
Overview of VPX Installation and Deployment
June 19, 2020
This section provides a summary of the steps involved for installing and deploying a
SD-WAN VPX-SE Virtual Appliance.
You can install SD-WAN VPX-SE on the following platforms:
VMware ESXi For instructions, see Installing and Deploying a SD-WAN VPX-SE on ESX.
XenServer The procedures for installinga SD-WAN VPX (VPX-SE) and a SD-WAN (WAN Optimiza-
tion) VPX are very similar. For instructions on installing a SD-WAN WANOP VPX on XenServer, see
the chapter entitled, “CloudBridge VPX, in the document entitled, Citrix CloudBridge 7.4 Prod-
uct Documentation, available on the Citrix Documentation Portal (http://docs.citrix.com/). See
also, Dierences Between a SD-WAN VPX-SE and WANOP VPX Installation.
Summary of Procedures for Deploying a SD-WAN VPX-VW on ESXI
The following list summarizes the steps and procedures involved in deploying a SD-WAN VPX-SE on a
VMware ESXi server.
1. Gather your SD-WAN VPX-SE installation and configuration information. For instructions, see
SD-WAN VPX-SE Installation and Configuration Checklist.
2. Install the VMware vSphere Client. For instructions, see Installing the VMware vSphere Client.
3. Install and deploy the SD-WAN VPX-SE OVF Template. For instructions, see Installing and De-
ploying the SD-WAN VPX-SE OVF Template.
4. Configure the SD-WAN VPX-SE Management IP Address. For instructions, see Configuring the
Management IP Address for the SD-WAN VPX-SE
5. Connect to the SD-WAN VPX-SE and test the deployment. For instructions, see Connecting to
the SD-WAN VPX-SE and Testing the Deployment.
Virtual Ethernet Ports Per VPX-SE/VPXL-SE Platforms
June 19, 2020
In SD-WAN 9.3 release, the VPX-SE/VPXL-SE platforms support 4 Virtual Ethernet interface only. This
leads to deployment issues when multiple VLANs are mapped to the same interface (debuggability).
In SD-WAN 10.0, support for additional ports for VPX-SEhigh availability deployments between servers
is added. This support would enable customers to map high availability interfaces one-to-one to real
ports to avoid any hypervisor misconfiguration that would separate the virtual appliances and cause
© 1999-2021 Citrix Systems, Inc. All rights reserved. 160

Table of Contents