Citrix SD-WAN Platforms
both virtual appliance to become active. Not all Hypervisors support nine Virtual Ports which is re-
quired to support the maximum configuration. If more ports are configured in the SD-WAN appliance
than available, SD-WAN supports the current configuration that has more SD-WAN ports than Hyper-
visor ports.
VPX Standard Edition on ESXi
May 23, 2019
This chapter provides step-by-step instructions for installing, configuring, and deploying the SD-WAN
VPX-SE. This includes basic instructions for installing the VMware vSphere Client, which you use to
create and deploy the SD-WAN VPX-SE Virtual Machine.
Note
VMware vSphere Client operation details might change with new releases of the vSphere so-
ware. For the most complete and current vSphere Client installation and operation instructions,
please refer to your VMware documentation. The instructions in this chapter are intended to
provide the most basic and essential guidelines, only, for installing an SD-WAN VPX-SE Virtual
Machine on the ESXi platform.
The following summarizes the top-level steps for installing and deploying an SD-WAN VPX-SE. Perform
these procedures in the exact order listed.
1. Install the VMware vSphere Client.
2. Install and deploy the SD-WAN VPX-SE OVF Template.
3. Configure the SD-WAN VPX-SE Management IP Address.
4. Connect and test the deployment.
Install Client
June 19, 2020
This section provides basic instructions for downloading and installing the VMware vSphere client you
use to create and deploy the SD-WAN VPX-SE Virtual Machine.
Note
Please refer to your VMware vSphere Client documentation for additional information. SD-WAN
can be deployed in vShpere Client version 5.5 or later.
© 1999-2021 Citrix Systems, Inc. All rights reserved. 161
To Next Page
Loading...
Need help?
General