Citrix SD-WAN Series User Manual

Citrix SD-WAN Platforms
Factory Reset
November 4, 2019
Factory Reset via button pushes
You can restore factory default settings on Citrix SD-WAN 210, 410 and 1100 appliances by performing
a reset via button pushes.
To perform factory reset on Citrix SD-WAN 410 appliance:
1. Power OFF the appliance using the power button.
Note
Ensure that the appliance is powered up, but is in OFF state.
2. Using a paper-clip, press and hold the NMI reset button for 5+ seconds or until the power LED
starts flashing.
3. While the power LED is flashing, press and release the power button to trigger the factory reset
process.
To perform factory reset on Citrix SD-WAN 210 and 1100 appliance:
1. Power OFF the appliance using the power button.
Note
Ensure that the appliance is powered up, but is in OFF state.
2. Using a paper-clip, press and release the NMI button, the power LED starts flashing.
3. Press and release the power button within 3 seconds to trigger the factory reset process.
Tip
• Pressing the NMI reset button even number of times cancels the reset action and results in
normal appliance reboot.
• Pressing the reset button odd number of times performs a factory reset.
• Power LED flash indicates that the appliance is being reset.
© 1999-2021 Citrix Systems, Inc. All rights reserved. 152

Citrix SD-WAN Series Specifications

General

Product Type	SD-WAN Appliance
Product Series	SD-WAN
Network Interfaces	Gigabit Ethernet
Performance	Varies by model
Form Factor	Rackmount
Management	CLI
Throughput	Varies by model
Interfaces	Ethernet
VPN Support	IPsec, SSL VPN
High Availability	Yes
Security Features	Firewall
WAN Optimization	Application Acceleration, Data Deduplication, Compression