Citrix SD-WAN Platforms
4. Insert the power supply into the slot and press against the semicircular handle until you hear
the power supply snap into place.
5. Connect the power supply to a power source.
Note
You can replace one power supply without shutting down the appliance, provided the other
power supply is working.
Solid-State Drive
May 23, 2019
A solid-state drive (SSD) is a high-performance device that stores data in solid-state flash memory.
Replace solid-state drive
The SD-WAN 4000/5000 soware is stored on the solid-state drive (SSD).
For Citrix SD-WAN 410 appliance, the on-board SATA disk controller must support at least two devices.
Support for SATAv3 (6 Gbps) is available.
To replace a solid-state drive
1. Shut down the appliance.
2. Locate the SSD on the back panel of the appliance. Push the safety latch of the drive cover
to the right or down, depending on the platform, while pulling out on the drive handle to
disengage. Pull out the faulty drive.
Figure 1. Removing the Existing Solid-State Drive
3. Verify that the replacement SSD is the correct type for the platform.
4. Pick up the new SSD, open the drive handle fully to the le or up, and insert the drive into the
slot as far as possible. To seat the drive, close the handle flush with the rear of the appliance so
© 1999-2021 Citrix Systems, Inc. All rights reserved. 416
To Next Page
Loading...
Need help?
General