Citrix SD-WAN Platforms
connecting the appliance to your computer with a serial null modem cable. Make sure that you have
physical access to the appliance.
To configure the appliance through the serial console
1. Connect a serial null modem cable to the appliance’s console port.
2. Connect the other end of the cable to the serial COM port of a computer running a terminal
emulator, such as Microso HyperTerminal, with settings 9600, N,8,1, p.
3. On the HyperTerminal output, press Enter. The terminal screen displays the Logon prompt.
Note: You might have to press Enter two or three times, depending on the terminal pro-
gram you are using.
4. At the logon prompt, log on to the appliance with the following default credentials:
• Username: nsroot
• Password: nsroot.
5. At the $ prompt, run the following command to switch to the shell prompt of the appliance:
$ ssh 169.254.0.10
6. Enter Yes to continue connecting to the management service.
7. Log on to the shell prompt of the appliance with the following default credentials:
• Password: nsroot.
8. At the logon prompt, run the following command to open the Management Service Initial Net-
work Address Configuration menu: ## networkconfig
9. Type 1 and press Enter to select option 1, and specify a new management IP address for the
management service.
10. Type 2 and press Enter to select option 2, and specify a new management IP address for the
XenServer server.
11. Type 3 and press Enter to select option 3, and then specify the network mask for the manage-
ment service IP address.
12. Type 4 and press Enter to select option 4, and then specify the default gateway for the manage-
ment service IP address.
13. Type 8 and press Enter to save the settings and exit.
14. Access the SD-WAN appliance by entering the new management service IP address of the appli-
ance, such as https://<Management_Service_IP_Address>, in a web browser of a com-
puter on the management network.
© 1999-2021 Citrix Systems, Inc. All rights reserved. 139
To Next Page
Loading...