Citrix SD-WAN Platforms
You can see 2 load balancer as following:
• External: External LB contains the public IP that you configure in the WAN link configura-
tion.
• Internal: Internal LB contains private IP. All LAN side traic comes to the internal LB. So
you can configure the route table with Internal LB IP as a next hop.
3. Proceed to the SD-WAN MCN appliance or SD-WAN Center to configure the SD-WAN HA site. In
this topic, the SDWSWEA and SDWSEASec appliances are the MCN appliances.
Note
You can configure Citrix SD-WAN HA in Azure through SD-WAN Orchestrator as well.
4. The SDWANSEA and SDWANSEASec Interface Group Configuration is provided as follows. By-
pass mode is set to fail-to-block since only one Ethernet/physical interface is used per virtual
interface. The WAN Interface must be set to Trusted to accept connections from the ALB.
© 1999-2021 Citrix Systems, Inc. All rights reserved. 373
To Next Page
Loading...