1.2.2 RHB LEXION 480 - 188 678.1
Safety Rules
Identification of warning and danger signs
All parts of this manual having to do with your safety
or the safe operation of the machine are marked
with the following signs. Please pass all safety
instructions on to other users, too.
DANGER!
Sign to indicate instructions which must be
observed. Failure to do so would cause
danger to life and limb to the operator and
the people around him.
☞ Preventive measures
ATTENTION!
Sign to indicate instructions which must be
observed. Failure to do so could result in
damage to the machine.
☞ Measures to prevent damage to the
machine.
NOTE!
Sign to indicate instructions for a more
efficient and economic use of the machine.
CAUTION!
Sign to indicate instructions to be followed
during disassembly / assembly.
ENVIRONMENT!
Sign to indicate instructions which must be
observed in order to avoid damage to the
environment.
Danger to the environment is caused by irregular
handling and incorrect disposal of toxic material
(e.g. old oil).
The warning and instruction signs placed on the
machine provide important recommendations for
safe operating. These instructions involve your
safety – observe them at all times!
Correct use of the machine
Fitting and retrofitting of ancillary equipment which
is not originally manufactured by CLAAS, and, in
addition, also modifications and changes may only
be carried out with the consent of CLAAS, as any
such actions may have considerable adverse
effects on the safety and operational function of the
machine.
Any arbitrary modifications carried out on the
machine will relieve the manufacturer of all liability
for any resulting damage or injury.
General safety and accident prevention
regulations
1. In addition to the instructions contained in this
manual, also observe the general safety and
accident prevention regulations.
2. Always comply with local traffic regulations
when driving on public roads.
3. Before starting the engine ensure that the
transmission is in neutral and that all guards
are installed and in their correct position.
4. Start the engine only from the operator's seat.
Never attempt to start the engine by shortening
across the starting motor terminals as the
machine may immediately start to move.
5. Before moving away, always check the
immediate vicinity of the machine. Ensure
adequate visibility. For a warning, always blow
the horn before starting up!
6. Never run the engine in a closed building!
7. Clothing worn by the fitter must be close-fitting.
Avoid wearing loose jackets, shirts or ties.
8. Handle fuel with care. – It is highly flammable.
Never refuel the machine in the vicinity of
naked flames or sparks.
Do not smoke during refuelling!
9. Always stop the engine and remove the ignition
key before refuelling. Fill the fuel tank outdoors.
Clean up any spilled fuel immediately!
10. Prevent fires by keeping the machine clean!
11. Take care when handling brake fluid and
battery acid (toxic and corrosive)!
12. Always blow the horn before starting the engine
and engaging the main drive.
To Next Page
