7.19.18 RHB LEXION 480 - 188 678.1
Manual gearbox
6. Install the bearing (9) and bolt the flanged
housing (16) in place with the seal.
Insert hex. bolts (17) with sealing compound.
(Fig. 53, 59)
7. Check the axial play of the main shaft.
The play must be 0.10 mm to 1.04 mm.
(Fig. 60)
Install the shifter rails.
Install manual gearbox.
Installing the drive shaft
1. Heat the inner race of cylinder roller bearing (15)
to approx. 100 °C and install it.
2. Insert the circlip (11) into the notch.
(Fig. 61)
3. Feed the drive shaft into the gearbox from the
left-hand side and slide on the double sliding gear.
4. Install circlip (11).
(Fig. 61, 62)
59
60
61
62
To Next Page
