Claas LEXION 480 - Assembling the Front Sieve Pan Drive Deflection Pulley; Installing the Front Sieve Pan Drive Deflection Pulley; Removing the Rear Sieve Pan Drive Deflection Pulley

188 678.1 - RHB LEXION 480 7.13.5
Sieve pan drive
Assembling the front sieve pan drive deflection
pulley
Insert the spacer ring (6), the circlips (5) and the deep
groove ball bearings (4) into the deflection pulley (2).
Bolt the deflection pulley to the base plate (1).
CAUTION!
Ensure correct installation position of the
deflection pulley.
Tightening torque
M 16-8.8 = 130 Nm
(Fig. 10, 11)
Installing the front sieve pan drive deflection
pulley
Bolt down the base plate (1) completely with the
deflection pulley.
Install and tension the sieve pan drive belt (15).
Pre-tension compression spring (D) by way of nut (E)
to the gauge rod length. Lock nuts (E and K) and
tighten clamping screw (A).
Tightening torque
M 16 = 130 Nm
(Fig. 8, 12)
Removing the rear sieve pan drive deflection
pulley
From serial no. …:
Fold down the toolbox. For this, unscrew the two
hex. bolts (S).
(Fig. 13)
11
12
13