188 678.1 - RHB LEXION 480 2.4.1
Foot brake
FOOT BRAKE
Removing the master brake cylinder
Drain the brake fluid into a container.
ENVIRONMENT!
Dispose of used brake fluid in a way that is harmless
to the environment and in accordance with existing
anti-pollution regulations.
Unscrew the brake lines from the master brake
cylinder.
Remove the split pin and the pin from the yoke of the
cylinder.
Unscrew the hex. securing bolts from the master
cylinder and remove master cylinder.
(Fig. 1)
Master brake cylinder, disassembled
1 Spring guide tube
2 Compression spring
3Seal
4 Washers
5Piston
6Circlip
7 Fixing ring
8Bellows
9Yoke
(Fig. 2)
Assembling the master brake cylinder
1. Fit the seal into the master cylinder.
2. Push the piston along with piston rod and
compression spring into the housing.
3. Secure the piston rod with the fixing ring and the
circlip.
4. Fit the bellows on the piston rod and screw in the
yoke.
(Fig. 2)
1
2
Foot brake
To Next Page
