Claas LEXION 480 - Specifications; Lubricants Chart

188 678.1 - RHB LEXION 480 1.5.1
Specifications
SPECIFICATIONS
Lubricants chart
Component Type of lubricant Viscosity Capacity
Hydraulic system Multi-grade hydraulic oil
ISO-VG 46 conforming to
DIN 51 524 specifications,
part 3**
approx. 20 litres
(oil change)
approx. 70 litres
(new system filling)
Manual gearbox
20 t / 17 t
Multi-grade gearbox oil
conforming to
(MIL-L-2105 B)
API-GL-5-90 specifications
90
7.0 litres
Manual gearbox
20 t HD
6.5 litres
Final drives
20 t / 17 t
8.0 litres each
Planetary gearbox
20 t
5.0 litres each
Uni-spreader fan gearbox
(751 480.1)
0.48 litres
Uni-spreader fan gearbox
(763 099.1)
0.6 litres
Threshing drum
reduction gearbox
Multi-grade gearbox oil
conforming to
(MIL-L-2105)
API-GL-4-90 specifications
90
1.8 litres
Transfer gearbox
(engine output shaft)
3.0 litres
Rotor drives 1.75 litres each
Grain tank unloading tube
Upper angle drive
Rolling bearing grease,
e.g. Alvania R3
270 g
Grain tank unloading tube
Lower angle drive
(up to serial no. …)
530 g
Grain tank unloading tube
Lower angle drive
(from serial no. …)
900 g
Foot brake ATE brake fluid SAE-specifications
DOT 4
Reservoir must
always be full
SANDEN compressor SD 7 H 15 Sanden oil SP 20 PAG as required
(approx. 300 cm³
for initial filling)
Refrigerant R 134a 1800 g
** When selecting the hydraulic oil, the following conditions need to be met:
Pour point < -25 °C (DIN ISO 3016)
Viscosity 0 °C < 600 cSt. (DIN 51 562)
Viscosity 40 °C max. 50.6 cSt. (DIN 51 562)
Viscosity index > 170 (DIN ISO 2909)
The oil must have detergent properties!
Specifications